| Frequency range | |
| Channel 1 | |
| Normal mode | 10 Hz to 125 MHz |
| Low pass filter | 10 Hz to 50 kHz |
| Channel 2 | |
| 50 MHz to 26.5 GHz |
| Maximum input | |
| Channel 1 | 2 Vrms |
| Channel 2 | |
| 50 MHz to 2 GHz | +5 dBm |
| 2–46 GHz | +13 dBm |
| Impedance (nominal) | |
| Channel 1 | 1 Mohm/60 pF |
| Channel 2 | 50 ohm |
| Connector | |
| Channel 1 | BNC female |
| Channel 2 | SMA/APC-3.5 compatible female |
| Power Meter Specifications | |
| Frequency range | 100 kHz to 50 GHz, sensor dependent. |
| Power range | -70 to +44 dBm, sensor dependent. |
| Power sensors | supported 8480 series (see table on page 8) |
| Resolution | 0.01 dB in log mode, 0.1% of full scale in linear mode. |
| Power reference | |
| Power output | 1.00 mW. Factory set to ± 0.7%, traceable to NIST. |
| Accuracy | ±1.2% worst case (± 0.9 RSS) for one year. |
| Frequency | 50 MHz (nominal) |
| Connector | N (f) |
| DVM Specifications | |
| Function | DC volts |
| Range | ±50 Vdc |
| Resolution | 2 mV |
| Accuracy | ±0.25% of reading ±10 mV |
| Damage level | ±60 Vdc |
| Input resistance | 0.5 Mohm (nominal) |
| Connector | 4 mm banana sockets |
| Display | Replaces frequency display when DVM activated |
| General Information | |
| Weight (nominal) 4.5 kg without battery option,6.6 kg with battery option |
| Operating temperature | 0 to 55° C |
| Size | 330 mm W x 156 mm H x 376 mm D with bumpers and handles. Rack panel is full EIA width and 3U ISO height |
| Power Supply | |
| ac | 90–132 Vac; 47.5–66 Hz or 360–440 Hz 216–264 Vac; 47.5–66Hz |
| Line selection Power requirements | automatic 80 VA max. (32 W typical) |
| dc (Option 002 only) | 11–18 Vdc; 2A max. |